Monacor International JTS PT-36BG2/5 Mode D'emploi page 10

the sound, press the button once again; the
display will briefly indicate
To switch off, keep the button POWER / MUTE
pressed until the display indicates
7 Settings
Use the buttons SET,
settings for the pocket transmitter:
1) To call up the setting mode, keep the but-
ton SET pressed for 3 seconds: The display in-
dicates
("Selecting a frequency from a group" or
"Setting the frequency directly", whichever
function was used to set the current trans-
mission frequency)
2) To select a function, use the button SET:
Press the button repeatedly until the desired
function is reached
Overview of functions
1. "Selecting a frequency from a group"
(or "Setting the frequency directly")

2. "Setting the frequency directly"
(or "Selecting a frequency from a group")

3. "Adjusting the sensitivity"

4. "Level attenuation"

5. "Selecting the transmission power"

6. "Key lock"
3) To change the setting, use the button
or When a function offers two setting
options (e g group number and channel
number), use the button SET to go from the
first option to the second option
4) To save the setting, press the button SET
The display indicates
mode is exited
If no setting has been changed when the last
function is reached, the setting mode will be
exited when the button SET is pressed (indica-
tion )
For detailed information on the functions refer
to the following chapters
10
and (4) to make
and the first function is selected
and the setting
7.1 Selecting a frequency from a group
Just like on the receiver US-36G2 / 5, the trans-
mission frequency can be selected from one of
the 6 preset groups (overview:
detailed information on this function refer to
the instructions of the receiver
1) The group number (in front of the hyphen)
starts flashing on the display: Use the button
or to select the group
2) Press the button SET
3) The channel number starts flashing on the
display: Use the button
the channel
4) To save the setting, press the button SET
7.2 Setting the frequency directly
Just like on the receiver US-36G2 / 5, the desired
frequency can be selected from 1441 available
frequencies
1) The first three digits of the transmission fre-
quency start flashing on the display: Use the
button or to set the frequency in steps
of 1 MHz
2) Press the button SET
3) The last three digits of the transmission fre-
quency start flashing: Use the button
to set the frequency in steps of 0 025 MHz
4) To save the setting, press the button SET
7.3 Adjusting the sensitivity
The sensitivity adjustment (in steps of 3 dB
from –18 dB to +12 dB) is used to match the
microphone input (2) to the signal level of the
microphone connected Adjust the sensitivity
in such a way that an ideal volume level of the
microphone is obtained When the volume is too
high, the microphone signal will distort; in this
case, adjust a lower value When the volume is
too low, the signal-noise ratio will be poor; in
this case, adjust a higher value
1) The display briefly indicates
by the current sensitivity in dB Use the but-
ton to adjust a higher value or the button
to adjust a lower value
2) To save the setting, press the button SET
page 3) For
☞
or to select
or
followed