WEBTEC FI750 Manuel D'utilisation page 3

Introduction
Flow Indicators are designed for continuous monitoring or intermittent use commissioning and servicing hydraulic systems up to 420 bar
(6000 psi). The large clear 63 mm (2.5") diameter dial ensures that quick checks can be made to determine pump performance and setting
of flow control valves. They can be used on mobile and industrial hydraulic circuits, also lubrication and coolant systems using oil. These
direct acting flow indicators can be installed in hazardous areas or on applications where no power is available. The flow indicator design
ensures good reliability and minimises the effects of contamination.
The FI range of products is divided into two families:
1. FI750
2. FI1500
This manual covers the FI750 range of products.
Before first operating the equipment read the whole of these instructions. Safety may be impaired if they are not followed.
Webtec have been designing and manufacturing flow meters and hydraulics components for over 40 years. We operate within a Quality
Management System that complies with the requirements of BS EN ISO 9001:2000 which is externally audited and certificated each year.
Beyond compliance to the standard, Webtec is committed to continually improving in everything we do; with particular emphasis on
understanding what matters to our customers and suppliers, and designing our systems and work to meet their needs. We are always keen
to hear from customers who may have special requirements not covered by our standard ranges
1