Care And Cleaning - Jenn-Air JIM1550ACX Guide Du Propriétaire

CAUTION
• Avoid leaning on the cabinet door, you may bend
the door hinge or tip the ice maker.
Both the ice making system and the condenser need to
be cleaned regularly.
Cleaning the Ice Maker
System
Some impurities and minerals will remain and build-up
in the ice maker and stick to the ice maker's parts over
time. This build-up must be removed for proper ice
production, ice quality, and ice maker life. Your ice
maker is equipped with a cleaning mode that will help
in cleaning out these impurities.
Clean the ice and water system at least annually to
remove buildup. Frequency of cleaning depends on
water hardness. With very hard water ( >14 gpg),
cleaning may be required as frequently as every
6 months.
To clean the ice maker:
1. Switch the selector switch to the
OFF position (see page 13).
2. Wait approximately 10 minutes for the ice to fall
into the storage bin. Remove all ice from the
storage bin.
3. Remove the drain plug at the bottom of the
reservoir to drain any remaining water and then
reinstall.
4. Unscrew and remove interior stainless steel front
cover panel to gain access to the reservoir.
5. Determine the amount of ice maker cleaner
needed, based on 3 quarts
of water (refer to the cleaner
manufacturer's directions).
Pour this amount of ice
maker cleaner into the
reservoir of the ice maker.
NOTE: "Ice Maker Cleaner Appliance" by Vapco
Products, a Division of Garman Co., Inc. is
recommended. It is available from
www.vapcoproducts.com (1-800-466-5150) or
many refrigeration supply and hardware stores.

Care and Cleaning

C
O
O L
F E
N
A
F
N
Reservoir Drain
Plug
WARNING
• Read and follow manufacturer's warnings on ice
machine cleaner products. Personal injury can
result when used improperly.
6. Replace front cover panel and close door.
7. Switch selector switch on the grill of the machine
to the CLEAN position. Three quarts of water will
automatically be added to ice maker cleaner.
8. The total cleaning time will end in approximately
49 minutes. The cleaning cycle will automatically
rinse the evaporator plate and also drain the
cleaning solution and rinse water.
9. After the cleaning cycle has ended, remove the
front cover panel again and check that build up
has been removed. The evaporator plate should be
clean, shiny, and smooth to the touch. If not and
build up is still visible, repeat the cleaning cycle
above. If build up is removed, continue below.
10. Disconnect power to the ice maker.
CAUTION
• Disconnect power to the ice maker for steps 11-14.
11. Remove the distributor tube, hose clamp, hose and
its rubber ends.
12. Thoroughly clean the inside of the distributor tube
and the spray holes. You can use the same
cleaning solution as before and an old tooth brush
to reach the inside of the distributor tube, rinse
thoroughly.
13. Reinstall the rubber end, hose, and hose clamp to
the distributor and then reinstall the distributor
tube to the evaporator with the spray holes pointed
to the bottom of the evaporator plate. Reinstall the
front cover panel.
14. Clean the ice maker's interior, ice scoop, interior
door panel, and door gasket with mild detergent
and water. Using two tablespoons of baking soda
in one quart of warm water while cleaning will help
remove odors. Rinse with fresh water. DO NOT
USE ANY ABRASIVE CLEANING PRODUCTS.
Your ice maker is now clean and may be put back into
operation by reconnecting the power and switching the
selector switch to the ON position.
NOTE: Discard the first harvest of ice cubes produced
after the clean cycle has been run.
11