Table des Matières
Publicité
Four Screws
Quatre vis
Cuatro Tornillos
➢ Lay unit on floor bottom up with
➢ Install the four screws to the nozzle
➢ Route nozzle hose to hose holder.
➢ Return the vacuum cleaner to the
Cleaning Agitator
➢ Clean agitator after every five uses
➢ Remove lower plate. (See
➢ Cut off any hair, thread, string,
➢ Remove agitator. (See REPLACING
➢ Remove any string or debris located
➢ Reinstall agitator and lower plate.
- 46 -
nozzle flat.
cover.
Align nozzle hose bracket with
retaining bracket on body and slide
down unit it clicks into place.
upright position before plugging
into an electrical outlet.
and every time the belt is replaced.
REPLACING BELT, p. 42, 44)
carpet pile, and lint entangled
around agitator with a pair of
scissors.
BELT, p. 44)
on the end caps, washers or agitator
shaft.
(See REPLACING BELT, p. 44)
Publicité
Table des Matières
