GreenWorks CKF301 Manuel Opérateur page 11

EN
11. Tighten the chain cover knob when the chain is correctly
tensioned.
If you start the chain saw with a new chain, have a test for
2-3 minutes. A new chain gets longer after the first use,
examine the tension and tighten the chain if necessary.
11.1.3 FIT THE POLE SAW
5
1. Mount the pole saw head (16) on pole saw handle (4) to
achieve the standard length.
2. Slide the collar (5) upwards.
3. Turn the collar clockwise to tight it.
11.1.4 EXTENSION OF THE POLE SAW
1. Fit the extension pole between the pole saw handle and
the pole saw head to achieve the maximum length.
2. Slide the collars upwards.
3. Turn the collars clockwise to tight them.
Periodically check the tightness of the connection of the
collars.
11.1.5 FIT THE HEDGE TRIMMER HEAD
NOTE
4
6
16
WARNING
English
The hedge trimmer head can be mounted directly into handle
pole so as to achieve the standard length.
1. Insert the rear handle into the hedge trimmer head.
2. Slide the coupler and turn it until it is completely
tightened.
Periodically check the connections to ensure that they are
tightened securely.
11.1.6 REMOVE THE HEDGE TRIMMER
HEAD
1. Rest the machine on the ground.
2. Loosen the coupler.
3. Take off the hedge trimmer head.
11.1.7 INSTALL THE BATTERY PACK
5
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the motor stops before
you install or remove the battery pack.
• Read and understand the instructions in the battery and
charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
11.1.8 REMOVE THE BATTERY PACK
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
10
WARNING
WARNING