AXIL AN0256E Manuel D'utilisation page 8

INDOOR AMPLIFIED ANTENNA
A
This is a high gain and low noise indoor antenna, it can receive and amplify TV and RADIO
signalsto improve reception on the UHF , VHF and FM bands.
This antenna can only be used indoors.
Please connect the power supply according to the diagram FIG1.
When using Dc 12v, pay attention to the power supply polarity, which is marked on the back
plate of the appliance.
The main plug (or 12v source plug) is used as the disconnect device, the power socket must
be easily accessible.
If the appliance is not to be used for an extended period, unplug the antenna from the supply.
Attention: Never use mains voltage and 12 volts together. Use one or the other.
·The Green gain light will come on as
soon as the aerial is switched on.
·The green gain light signifies low signals.
·The Red gain light signifies higher signals.
·If the picture is snowy you can adjust the
gain control until the picture is clear.
You may find that you need to experiment with moving the aerial around and adjusting the gain
control to achieve the best reception possible.
Note: It is not always possible to get a perfect picture if the signals in your area are weak.
·The centre element can be rotated through 90 degrees for vertical and horizontal polarization.
·Extend the two Radio aerial whips fully for best radio reception.
·Read these instructions carefully before you try to use the aerial.
·Protect the mains lead. You must make sure the mains lead cannot be walked on, crushed,
chafed, cut, and so on.
Description & Instructions
230 VAC
50/60Hz
230 VAC
+
12 VDC
EXT ANT 100mA TO TV
To TV
Outdoor
12VDC
Antenna
Adapter
(optional)
for camping
(optional)
Red gain light
ON/OFF and
Gain Regulator
Green gain light