Operation - Dometic CK40D Hybrid Notice D'utilisation

CK40D Hybrid
In thermoelectric mode you don't have to set the temperature. The display is
deactivated.
In compressor mode, you can use the buttons to set the temperature within a
range from +10 °C to –15 °C. The display shows the temperature.
The lid is sealed continuously and has a magnetic lock.
The cooler has the following operating elements:
Item in fig. 2,
Description
page 3
1 Display
2 ON/OFF
3 TEMP –
4 TEMP +
6

Operation

I
NOTE
• Before starting your new coolbox for the first time, you should clean
it inside and outside with a damp cloth for hygienic reasons (please
also refer to the chapter "Cleaning and care" on page 12).
• A few water drops may form inside the cooler if it has been cooling
for a lengthy period. This is normal because the moisture in the air
condenses to water when the temperature in the cooler falls. The
cooler is not defective. Wipe it out with a dry cloth if necessary.
6.1 Energy saving tips
• Choose a well ventilated location which is protected from direct sunlight.
• Allow warm food to cool down first before placing it in the cooling device to
keep cool.
• Do not open the cooling device more often than necessary.
• Do not leave the cooling device open for longer than necessary.
EN
Explanation
Displays the current or the desired temperature,
respectively.
Switches the cooler on or off.
Decreases the desired cooling temperature by
1 °C.
Increases the desired cooling temperature by
1 °C.
Operation
9