Installation; Transportation - Giatsu GIA-ATS-O-300VAW Manuel De L'utilisateur Et D'installation

INSTALLATION

 Asked your supplier to install the unit. Incomplete installation performed by yourself
may result in a water leakage, electric shock, or fire.
 Indoor installation is highly recommended. It is not allow to install the unit at outdoor
or rain achieving place.
 The installation place without direct sunlight and other heat supplies is
recommended. If no way to avoid these, please install a covering.
 The unit must be securely fixed to avoid noise and shaking.
 Make sure that there's no obstacle around the unit.
 In the place where there is strong wind, fix the unit in the location protected from the
wind.

Transportation

As a rule, the unit is to be stored and/or transported in its shipping container in upright position and
without water charge. For a transport over short distance (provided that it is done with care), an
inclination angle up to 30 degrees is permitted, both during transport and storage. Ambient
temperatures of –20 to +70 degrees Celsius are permitted.
- Transport using a forklift
When transported by a forklift, the unit must remain mounted on the pallet. The lifting rate should be
kept to a minimum. Due to its top-heaviness, the unit must be secured against tipping over.
To prevent any damage, the unit must be placed on a level surface.
Manual transport
-
For the manual transport, a wooden/plastic pallet can be used. Using ropes or carrying straps, a
second or third handling configuration is possible. With this type of handling, it is advised that the
maximum permissible inclination angle of 45 degree is not exceeded. If transport in an inclined
position cannot be avoided, the unit should be taken into operation one hour after it has been
moved into final position.
ATTENTION: DUE TO THE HIGH CENTER OF GRAVITY, LOW OVERTURNING MOMENT,
THE UNIT MUST BE SECURED AGAINST TIPPING OVER.
54