Publicité
Les langues disponibles
Les langues disponibles
Helpful Tips:
1)
If heater will not turn on, check main power switch. Rear of Appliance.
2)
Check air filter, clean as needed.
3)
If your room has minimal heat loss, and is closed off to cooler areas you may be able to reduce the cost of
operation by setting the heater to low after the room has reached a comfortable temperature.
4)
If remote is lost you can still operate the heater manually.
Do not drag your heater across the room by pulling it by the cord. Store cord on cord wrap when not in use.
5)
6)
Use the timer to turn off your heater and save energy
7)
Cool Down feature: When the thermostat cycles "off" or when you turn the unit off the fan will continue to run
for a few moments to finish distributing the heat and to cool down the heaters heating elements.
OPERATING INSTRUCTIONS
1. Turn Main Power switch on rear of appliance to On.
2. Start and select working mode
Appliance
Turn the heater on by pressing the power button on the control
panel or by pressing the Power button on the remote control.
Two quick beeps indicate power to the unit.
Heaer will turn on in Auto Mode at the lowest set temperature of
59°.
Select a heat Mode
Press the HEAT button to toggle between the two heat settings
Auto and High.
Remote
Under Auto Heat-up mode, when the difference between set
temp and room temo exceeds 5° F, the unit will run at full 1500w,
Otherwise unit will run at 750w.
High Heat-up mode, the unit will runs at a consistant 1500w,
when temp exceeds 86° F unit will cycle off.
7
Publicité
