ASROCK ConRoe1333-D667 Mode D'emploi page 13

Les langues disponibles

2.4 Expansion Slots (PCI, HDMR and PCI Express Slots)

There are 2 PCI slots, 1 HDMR slot and 2 PCI Express slots on this motherboard.

PCI slots: PCI slots are used to install expansion cards that have the 32-bit PCI

interface.

HDMR slot: HDMR slot is used to insert a HDMR card with v.92 Modem

functionality. The HDMR slot is shared with PCI2 slot.

PCIE Slots: PCIE1 (PCIE x16 slot) is used for PCI Express cards with x16 lane

width graphics cards.

PCIE2 (PCIE x1 slot) is used for PCI Express cards with x1 lane

width cards, such as Gigabit LAN card, SATA2 card, etc.

If you install the add-on PCI Express VGA card to PCIE1 (PCIE x16 slot),

the onboard VGA will be disabled. If you install the add-on PCI Express VGA

card to PCIE1 (PCIE x16 slot) and adjust the "Internal Graphics Mode Select"

BIOS option to [Enabled], the onboard VGA will be enabled, and the primary

screen will be onboard VGA.

Installing an expansion card

Step 1.

Before installing the expansion card, please make sure that the power

supply is switched off or the power cord is unplugged. Please read the

documentation of the expansion card and make necessary hardware

settings for the card before you start the installation.

Step 2.

Remove the bracket facing the slot that you intend to use. Keep the screws

for later use.

Step 3.

Align the card connector with the slot and press firmly until the card is

completely seated on the slot.

Step 4.

Fasten the card to the chassis with screws.

ASRock ConRoe1333-D667 Motherboard

1 3