ASSEMBLE THE CART TO YOUR VEHICLE
STEP 7:
(SEE FIGURE 7)
• Use the clevis pin (O) and hair cotter pin (P) to attach
the cart to the towing vehicle.
O
P
CAUTION: an unlatched cart may tip
back into latch position when un-
loading from the rear of the cart
CAUTION: to avoid possible injury,
be sure that no one else is near the
cart when unloading the cart
CAUTION: to avoid possible injury,
be sure no one is near the cart when
releasing the latch
CAUTION: vehicle braking and stability
may be affected with the addition of an
accessory or an attachment. Be aware
of changing conditions on slopes.
OPERATION
• Be sure the cart is securely attached to the towing
vehicle.
• Check tires for correct air pressure before each use.
• Check for loose hardware before each use.
• Always begin towing slowly and gradually increase
speed as conditions permit.
• The maximum weight capacity is 1250 lbs.
• Maximum towing speed is 5 m.p.h.
• For best handling and traction, distribute the load
evenly in the cart.
• Use caution near the trailer tilt latch. Be sure the latch
is engaged before each use.
• When unloading by hand, if possible unload the front
of the cart first when in the dump position - unloading
the cart from the rear when unlatched will cause an
uneven load and the cart may tilt back into the latch
position.
FIGURE 7
MAINTENANCE
• Always clean the cart after each use.
• At the beginning of each season, using a light machine
oil, lubricate the latch and the tongue pivot point.
• Frequently check the grease level of the wheels to
prevent bearings from excessive wear or failure.
• Keep tires filled to the recommended tire pressure
printed on the tire. Maximum psi is 24.
7