Table des Matières
Publicité
ATTACH THE TONGUE ASSEMBLY
STEP 4:
(SEE FIGURE 4)
• Ensure the frame assembly is upside down.
• Attach the tongue assembly to the frame assembly
by inserting the short end of the two axle spindles (6)
through the axle mounting plates (4) and threading
into the axle tube (5). Thread axle spindles until snug
and then loosen until holes in the axle tube and
spindles are aligned. Secure the two axle spindles
to the axle tube using two M6x45 mm bolts (L) and
M6 locknuts (F).
6
4
F
ATTACH THE WHEELS
STEP 5:
(SEE FIGURE 5)
• Turn the cart assembly over.
• Slide the two wheels (13) onto the axle spindles (6)
with grease zerks and valve stems facing out. Secure
with two 20 mm castle nuts (D) and 20 mm steel
washers (A). Tighten the castle nuts then back off half
a turn to allow the wheels to spin.
• Insert the two cotter pins (N) through the axle spindles
(6) and castle nuts (D) Spread the ends of the cotter
pin around the axle using a pair of pliers.
• Tighten all hardware. Be sure not to over tighten.
• Grease both wheels with a grease gun.
IMPORTANT: Keep tires filled to the recommended tire
pressure printed on the tire. Recommended operating
pressure is 24 psi.
L
5
6
4
FIGURE 4
ASSEMBLE THE CONTAINMENT RACKS
STEP 6:
(SEE FIGURE 6)
• Slide the tailgate (3) into the channels on the rear
trailer frame (2). Slide the four side containment
racks (8) and one front containment rack (9) into the
corresponding tubes on the trailer frame assembly.
9
6
13
N
6
A
D
FIGURE 5
8
3
2
FIGURE 6
Publicité
Table des Matières
