HSM 386.2 Notice D'utilisation page 8

HSM 386.2
Before changing the location,
cleaning or anything else other
than normal operation
turn off and unplug the paper
shredder!
Mainte nan ce and ser vi ce work
may be per for med on ly by:
• HSM cu sto mer ser vi ce
• spe cial ly trai ned staff
(e.g. qua li fi ed electri cians)
• ser vi ce tech ni cians from our
con tracting part ners
4. Installation
• This paper shredder should never be
placed near or over a radiator or heat
source.
• The ventilation slots must not be blocked
or covered and they must be at a distance
of at least 10 cm away from walls or furni-
ture.
• Make sure the mains plug is easily acces-
sible.
• Before plugging in the mains plug, check
that the voltage and frequency of your
local mains supply correspond to those
stated on the type plate.
Before start-up:
Undo the wing screws securing the unit du-
ring transportation.
8
All manuals and user guides at all-guides.com
Paper shredder
5. Put ting in to ope ra ti on
Switching the paper shredder on
Feed paper
• When the paper fee ding opening is free
again, the cut ting sy stem au to ma tical ly swit-
ches off af ter app rox. 3 sec. and returns to
standby.
Swit ching paper shredder off
6. Scope of delivery
• Paper shredder, ready for connection, in
carton packing
• 5 Bags for shredded material
• Special cutting block oil 50 ml (cross cut)
• Operating instructions
• Tray for continuous shredding of computer
listings, order No.: 1.442.050.051
• Bag for shredded material,
order No.: 1.410.995.000
• Special cutting block oil 250 ml,
order No.: 1.235.997.401
english
• Press rocker switch pos. 1.
1
• Rocker switch locks in.
• Green LED lights.
• Paper shredder is ready for ope-
ration (standby).
See „Technical
data" for sheet
capacity.
• The shredding
pro cess is star ted
by a pho to –cell in
the paper feeding
opening.
• Tap rocker switch pos. 2.
• Rocker switch resets to zero
2
position.
Acces so ries:
0510