Ce Conformity Declaration; Specification - Multiplex Cockpit SX Mode D'emploi

Supplement to the manual
whether the receiving system responds to your con-
trol commands with clearly defined, smooth move-
ments of the corresponding control surface.
5. Increase the distance between the transmitter and
the model.
Note: changing the model's attitude
Constantly move (rotate, tip, incline) the model dur-
ing the range check, so that it does not apply to one
flight attitude only.
You have reached the range limit, when the servos no
longer respond distinctly and with constant movement
to your control commands.
The following have a strong influence on range ...
... environmental conditions.
Obstacles which detract from the visual link bet-
ween transmitter and model.
The type and quality of the terrain, and the weather
conditions.
... receiver technology and sophistication.
Technically sophisticated receivers offer greater
range than simple, small, low-cost receivers.
... conditions inside the model.
Aerial deployment, distance from batteries, motors,
ignition systems, metallic / carbon fibre parts all
have an effect on radio range.
Important: read the receiver instructions
For the actual range which should be achieved please
refer to the instructions supplied with the receiver you
are using.
The instructions also include important information re-
garding the installation and optimisation of the receiver
aerial(s).
Important if the model contains a power system:
Carry out the initial range check with the power system
switched off. Repeat the check with the power system
operating (varying throttle settings): there should be lit-
tle difference in the range achieved. If this is not the
case, you need to locate and eliminate the cause of the
interference (the motor itself, the arrangement of the
receiving system components and power supply, vibra-
tion, etc.).
MULTIPLEX Modellsport GmbH & Co.KG • Westliche Gewerbestraße 1 • D-75015 Bretten (Gölshausen) • www.multiplex-rc.de

6. CE Conformity Declaration

MULTIPLEX Modellsport GmbH & Co. KG hereby de-
clares that the device described in these instructions
fulfils the requirements of the following harmonised EU
directives:
Electromagnetic Compatibility and Radio Spectrum Matters (ERM)
EN 300 328, EN 300 328-2
EN-301 489-1, EN 301 489-3
Safety
EN 60950-1
A detailed CE Conformity Declaration can be found in
the form of a PDF file on the Internet at www.multiplex-
rc.de. You will find it in the DOWNLOADS area under
PRODUCT INFORMATION.

7. Specification

Channel count 7 servo channels
Model memories 18
Transmission 2.4 GHz FHSS M-LINK
method
Frequency 2.4000 – 2.4835 GHz or
range restricted frequency range
2.4000 – 2.44540 GHz
Servo signal
UNI
format
at 100% servo travel
Signal repeat 14 ms (Fast Response)
time 21 ms
Power supply Battery: 7.2 V, 1800 mAh
6 cells, AA-size, NiMH
Current drain ~ 80 mA incl. RF section
Operating tem-
– 15°C to + 55°C
perature range
Storage tem-
– 20°C to + 60°C
perature range
Dimensions Length
(hand-held)
Width
Height
Weight ~ 740 g incl. battery
(hand-held)
1.5 ± 0.55 ms
~ 190 mm
(~ 220 mm with aerial
fitted, angled at 90°)
~ 185 mm
~ 60 mm excl. sticks
and carry handle
Seite 3/9