Publicité
Les langues disponibles
Les langues disponibles
6. Press safety switch then trigger switch to start operation (see 4.3).
Apply light downward pressure on handles to drill hole.
Periodically, raise the auger to help clear drilling debris from the hole.
Do not apply excessive body weight on the machine.
Note: Overloading the auger during drilling may cause it to stop. When this occurs, lift the auger to
reduce the drilling load on the motor; and allow drilling debris to be cleared out of the hole.Then
resume drilling.
7. Once work is finished, stop product by releasing trigger switch.
Note: do not put down tool until the blade has completely come to a stop.
VI. MAINTENANCE AND STORAGE
Before any intervention on product, ensure that product is disconnected from its
power source.
6.1- Maintenance
Clean plastic parts with a soft and clean cloth
Do not use aggressive cleansers (solvents or abrasive cleansers), or an abrasive sponge.
Do not put or immerse product in water or any other liquid.
Clean drill bit with a brush after each use.
6.2- Storage
Store product, instructions manual and accessories in its original packaging.
Product must be stored in a dry location. Always lock up product and keep out of reach of children
6.3- Disposal
- do not dispose with household garbage. Do not throw into the environment.
Dispose of the product in a collection centre for waste of electrical and electronic equipment, or a
waste drop-off centre; or seek advice from your local municipality.
- Proceed with disposal of the tool, accessories and packaging according to local regulations
regarding the protection of the environment.
Publicité
