Stobag SKIMY SRCU 80M Instructions Et Avertissements Pour L'installation Et L'utilisation page 68

DAILY USE OF THE
TRANSMITTER
In daily use, the transmitter can be operat-
ed in two ways:
• SINGLE MODE - The command is sent
EN
to a single automation.
• GROUP MODE - The command is sent
to a group of automations.
CONTROLLING AUTOMATIONS IN
"SINGLE MODE"
To send a command to a single automa-
tion, proceed as follows:
• with the transmitter switched off, use
keys – / + to select the Number of the
required automation (*).
68
• send the command by pressing one of
the keys ▲, ■, ▼ or 1, 2, 3.
If one of the three control keys is sub-
sequently pressed, this command will be
sent to the previously used automation.
Note (*): If a selection is made from the
"Automation List" of an automation asso-
ciated with a radio code type
firming the selection by pressing OK the
symbol also appears on display. At this
point (before sending the command) one
of the following options can be selected by
pressing OK again:
- , by pressing OK once;
- , by pressing OK twice;
- (no command), by pressing OK
three times.
The command sent is managed by the
automation only when the latter manages
(and is connected to) a brightness sensor.
CONTROLLING AUTOMATIONS IN
"GROUP MODE"
To send a command to a group of automa-
tions, proceed as follows:
after con-
• with the transmitter switched off,
press OK;
• use keys – / + to select the required
Group from those created (*).
• send the command by pressing one of
the keys ▲, ■, ▼ or 1, 2, 3.
If one of the three control keys is sub-
sequently pressed, this command will be
sent to the previously used automation.
Note (*): At this point, before sending the
command, there is the option, by press-
ing OK, of using keys – / + to check which
automations are entered in the selected
Group (shown on the right of the display).