Publicité
Les langues disponibles
Les langues disponibles
03. At this point, press each of the six
transmitter keys once, in the following
sequence:
▲(1), ■(2), ▼(3), – , + , OK .
Each key, when pressed, will change
the display, scrolling forward through
the numbers until "P6" appears.
04. After pressing the last key (OK), the
display shows the following:
Then wait for the transmitter to switch
EN
off, thus completing the deletion pro-
cedure.
64
CREATING
AUTOMATION GROUPS
The section "USEFUL TIPS AND WARN-
INGS" outlines the main characteristics of
.
the operating mode named "Group Mode",
in which the transmitter can control the
required automations simultaneously.
This section describes how to create an
Automation Group in the transmitter.
PLANNING A GROUP
➑
Fig.
shows a purely guideline example
of a plan of 4 groups, simply to help you
understand the logic of group selection.
Then enter the following data, as required,
in the "OPERATION TABLE" (at the end of
the manual):
a) - Ensure that the section for "Single Auto-
mations" of the "OPERATION TABLE" is
already compiled; otherwise (important!)
contact the installation engineer to com-
pile this section.
b) - Decide which NUMBER to assign to
the Group and enter this in the relevant
section.
c) - Decide which automation is to be
included in the Group and cross check
the corresponding box.
MAKING A GROUP
Before performing this procedure, read the
section "AN OVERVIEW OF THE TRANS-
MITTER DISPLAY", which explains what
is normally displayed during these oper-
ations.
The following operative instructions explain
how to create a Group. The examples refer
➑
to Fig.
, and in particular to the data of
Group 03. Proceed as follows:
01. With the transmitter switched off,
press and hold the key OK for approx.
5 seconds, until the display shows the
Publicité
