Stobag SKIMY SRCU 80M Instructions Et Avertissements Pour L'installation Et L'utilisation page 61

5
10"
A B
C D
B
(A, B, C, D)
A
(01, 02, 03, ....)
D
(A, B, C, D)
A
(01, 02, 03, ....)
A
(A, B, C, D)
— Step 2.1 —
Personalising radio code
If your "Automation List" contains automa-
tions associated with the radio code type
, the 10 dip-switches on which this code is
based now need to be set, for each auto-
mation. To do this, proceed as follows:
01. With the transmitter switched off,
press and hold the key OK for approx.
10 seconds, until the display shows
the symbol - - - , (after the text
"PROG") then release the key immedi-
ately.
02. Press keys – / + to select the Number
of the automation using radio code
03. Then press OK to enter the mode for
setting the Dipswitches: the display
shows the current setting of dipswitch
➏
no. 01 (Fig. ).
04. To modify the setting of dipswitch no.
➏
and then press ▲(1)
01, refer to Fig.
to select On or ▼(3) to select Off, as
required.
05. Then move to the next dipswitch by
pressing key + (or key – to the previous
one) and use keys ▲(1) / ▼(3), to select
the required setting for this dipswitch,
i.e. either On or Off.
Then set the remaining dipswitches
(total 10), repeating point 05 for each
one, and after reaching dipswitch no.
10, press OK to terminate and exit the
procedure.
If your "Automation List" contains oth-
er automations associated with the radio
code type , the relative Dipswitches must
.
Dipswitch status (On / Off)
ON
C
OFF Dipswitch no. (01 / 10)
EN
6
61