AUTO-HAK SC01 Instructions De Montage page 4

FITTING INSTRUCTION
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
8
4
13
5
6
6
B
A
9
This towing hitch is designed to assembly in following cars:
SEAT IBIZA 3/5 doors, produced since 04.1993 till 01.1996, catalogue
number SC01 and is prepared to tow trailers max total weight 1100 kg and
max vertical load 75 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towing hitch depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towing hitch should be install in points described by a car producer.
4
B
9
1
C
3
From manufacturer
1. Get lower the muffler from rubber handles.
2. Underneath the car, through holes in chassis member drill holes inside
the trunk using bit ø12 mm. Next enlarge made holes using bit
8
ø17mm in wall only from inside of the trunk.
13
3. To enlarged holes put distance sleeves L=50mm (pos. 5)
4. Underneath the car apply main bar of the towing hitch (pos. 1) to
5
chassis members and fix using bolts M10x90mm (pos. 8) through
A
distance sleeves (pos. 5) and holes pos. A.
5. By big holes in chassis members put nuts on the jib (pos. 4) and fix it
through holes pos. B using bolts M10x35mm (pos. 9)
NOTE: On the left side put small distance sleeves ø25xø13x9mm
(pos. 6) before fixing.
7
6. Through holes pos. C reassemble the muffler using bolts M8x35mm
(pos. 10) from equipment.
7. Fix tow-ball (pos. 2) and socket plate (pos. 3) by bolts M12x75mm
(pos. 4) from equipment.
8. Fix tight all bolts according to the torque shown in the table.
9. Connect electric wires of 7-poles socket according to the instruction
of the car. (Recommend to make at authorized service station)
10. Complete paint layer damaged during installation.
2
After install the towing hitch you should get adequate note in registration book (at
authorised service station).The car should be equipped with:
•
Indicators
•
Tow mirrors
After 1000km check all bolts and nuts. The ball of towing hitch must be always
kept clear and conserve with a grease.
The instruction of the assembly
Torque settings for nuts and bolts (8,8):
M 8 - 25 Nm M 10 - 55 Nm
M 12 - 85 Nm M 14 - 135 Nm
NOTE