BaByliss ELECTROLISS Mode D'emploi page 9

model on the LCD screen. Abide
by the instructions since these
programmes are designed for
specific areas only.
8. Set the current intensity variator
going until you feel a slight tingling
sensation. Adjust the strength
of the current according to your
sensitivity and the ELECTROLISS
will adjust the duration of the
treatment
hourglass icon displayed on the
screen will tell you how long this is.
IMPORTANT: This treatment should not
be painful. In most cases, you will feel
almost nothing, or only a light tingling
sensation. If this is not the case, even
at a low intensity, move the contact
patch slightly away from the treatment
patches.
In any case, don't hesitate to use a
low intensity for the first treatment. If
you can tolerate it, slowly increase the
intensity over the following uses.
9. A three short bips signal the end of
each cycle while the contact patch
flashes on the screen. Remember
to remove all patches, including
the contact patch to treat another
section of the area.
0. Position the treatment patches
and the contact patch on a new
area and press the button to
start a new session with your
ELECTROLISS.
N.B. If the patches are removed during
use, the session stops automatically.
The precision stylet can be fitted with
4 different heads; choose the head for
the area you wish to treat: the wide
head for the upper lip, the narrower
head for isolated hair.
The conducting
improves the
automatically.
gel provided
precision stylet's
conductivity; apply generously to the
selected head.
Hold the stylet as you would a pair of
tweezers, making sure you place your
fingers on its ergonomic handle. Hold
the appliance in one had to press the
button, with the other hand hold
the stylet and touch the hair or area
to be treated with the head of the
appliance, making sure you hold the
metal head flat against your skin. (see
The
figure 4)
QUESTIONS/ANSWERS
• My appliance doesn't turn on?
Make sure the appliance is fully
charged before use.
• The screen goes out?
Make sure the appliance is fully
charged before use.
• My appliance goes out while starting
the programme?
Avoid pressing the start button too
long.
• My appliance doesn't start the
planned session?
Check that the patches are properly
connected.
Check that the patches are adhering
properly to your skin.
Check that the patches are moist
enough.
• The patches don't adhere to my skin
properly anymore?
Moisten the patches with a few drops
of water applied with the tips of your
fingers. Let the patch absorb the
moisture and the gel regain its
adherence then put the patch back
on the right side of its protective film,
or use the patch immediately.
9