Light Kit Assembly - Craftmade Beckham BEK54 Guide D'installation

9. Light Kit Assembly.

Remove 1 screw from motor plate on
underside of motor housing and partially
loosen the other 2 screws.
Align slotted holes in fitter plate with loosened
screws in motor plate, allowing molex
connectors to come through center hole in
fitter plate. Twist fitter plate to lock. Re-insert
screw that was previously removed and
securely tighten all 3 screws with a Phillips
screwdriver.
Remove 1 screw from underside of fitter plate
and partially loosen the other 2 screws.
Connect WHITE wire from motor housing to
WHITE wire from the LED light kit and BLUE
(or BLACK) wire from motor housing to
BLACK wire from LED light kit. Make sure
molex connections snap together completely.
Carefully arrange wiring within the back of
LED light kit. Align slotted holes in LED light
kit with loosened screws in fitter plate. Twist
LED light kit to lock. Re-insert screw that was
previously removed and securely tighten all
3 screws with a Phillips screwdriver.
Locate slots on shade and align with nodules
on inside of LED light kit.
shade and turn to the RIGHT (clockwise)
slides completely into place.
Gently push up on
until it
motor housing
motor plate
molex connections
motor housing
LED light kit
screw
motor housing
nodules
slots
page 9
fitter plate
screw
fitter plate
molex connections
shade