DITEC Arc B Manuel D'installation Et D'entretien page 11

5. MAINTENANCE PROGRAM (each 6 month)
Power off (230 V~ mains and batteries, if installed):
- Clean and lubricate the pivot pins.
- Check that fastening points are properly tightened.
Power on (230 V mains and batteries, if installed):
- Check the power adjustments.
- Check the operation of all command and safety functions (photocells).
- Check the good operation of the release.
ATTENTION: For spare parts, see the spares price list.
GENERAL SAFETY PRECAUTIONS
The following precautions are an integral and essential part of the product and must be supplied to the user.
Read them carefully as they contain important indications for the safe installation, use and maintenace.
These instruction must be kept and forwarded to all possible future user of the system.
ON
OFF
All installation, maintenance and repair work must be documented and made available to the user.
DITEC S.p.A.
Via Mons. Banfi, 3
21042 Caronno P.lla (VA) Italy
Tel.+39 02 963911 - Fax +39 02 9650314
www.ditec.it
TEAR OFF AND DELIVER TO USER
Operating instruction ARC B / BH
Electromechanical automatic system for swing gates.
RELEASE INSTRUCTION
In case of faulty operation or power failure, remove
the plug and insert the release key supplied in the
special hole on the cover. Turn clockwise to release
the right leaf; counterclockwise to release the left leaf.
Manually slide the gate open.
At end of operations, lock the geared motor again.
In case of breack down or malfunctioning of the product, disconnect from mains, do not attempt to
repair or intervene directly and contact only qualified personnel.
Failure to comply with the above may create a situation of danger.
All cleaning, maintenance or repair work must be carried out by qualified personnel.
In order to guarantee that the system works efficiently and correctly it is indispensable to comply
with the manufacturer's indications thus having the periodic maintenance of the motorised door or
gate carried out by qualified personnel.
In particular regular checks are recommended in order to verify that the safety devices are operating
correctly.
ISO 9001 - Cert. n° 0957/1
Attention: Lock and release operations must
be performed with motor not running.
This product must be used only for that which it has been
expressely designed.
Any other use is to be considered improper and therefore
dangerous.
The manufacturer cannot be held responsible for possible damage
caused by improper, erroneous or unresonable use.
Avoid operating in the proximity of the hinges or moving mechanical
parts.
Do not enter the field of action of the motorised door or gate while
in motion.
Do not obstruct the motion of the motorised door or gate as this
may cause a situation of danger.
Do not allow children to play or stay within the field of action of the
motorised door or gate.
Keep remote control or any other control devices out of the reach
of children, in order to avoid possible involuntary activation of the
motorised door or gate.
Installer: