AUTO-HAK W05 Instructions De Montage page 4

FITTING INSTRUCTION
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
A
1
5
This towing hitch is designed to assembly in following cars:
SUZUKI VITARA, 5 doors, produced since 1995, catalogue no. W05 and
is prepared to tow trailers max total weight 1875 kg and max vertical load
75 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towing hitch depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towing hitch should be install in points described by a car producer.
6
2
3
From manufacturer
1. Disassemble original towing eye (it will not be used
A
anymore).
2. Put the main bar of the towing hitch (pos. 1) underneath
the car to chassis frame and through holes A and original
threaded
M12x1.25x35mm (pos. 5) from towing hitch accessories.
3. To installed bar of the towing hitch fix the tow-ball (pos.
5
2) using bolts M16x50mm (pos. 4) from accessories.
4. Fix the socket plate (pos. 3) using bolt M10x30mm (pos.
15
6).
5. Tighten all bolts according to the torque shown in the
table.
6. Connect electric wires of 7-poles socket according to the
instruction of the car. (Recommend to make at authorized
service station).
7. Complete paint layer damaged during installation.
4
After install the towing hitch you should get adequate note in
registration book (at authorised service station).The car should
be equipped with:
• Indicators
• Tow mirrors
After 1000km check all bolts. The ball of towing hitch must be
always kept clear and conserve with a grease.
The instruction of the assembly
holes in the
Torque settings for nuts and bolts (8,8):
M6 - 11 Nm M8 - 25 Nm
M12 - 87 Nm M14 - 138 Nm
NOTE
frame fix using bolts
M10 - 50 Nm
M16 - 210 Nm