Publicité
Les langues disponibles
Les langues disponibles
FITTING INSTRUCTION
Clamp mark
in acc. with
Cables joining
ISO
PN
1
L
Left directional lights
2
+
Rear fog lights
3
31
Ground
4
R
Right directional lights
5
58R
Right side parking lights
6
54
Stoplights
7
58L
Left side parking lights
10
11
15
E
5
E
11
This towing hitch is designed to assembly in following car:
FIAT BRAVO, 3 doors (182), produced since 09.1995 till 10.2001,
catalogue no. R10 and is prepared to tow trailers max total weight 1400 kg
and max vertical load 75 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towing hitch depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towing hitch should be installed in points described by a car producer.
D
7
9
B
8
3
From manufacturer
1.
Take out a spare wheel. Disassemble a bumper and remove its filling.
11
2.
Inside trunk disassemble cover plates of sides and rear wall and take out felt-
mat from spare wheel housing.
C
3.
On the left and right side of rear wall twist off plugs off chassis members and
remove rest of rivet.
6
4.
Put main bar of the towing hitch (pos. 1) to rear wall (in axis) and then
through holes (pos. A) drill holes using bit ø9mm.
A
5.
Underneath a car put angle elements (pos. 6) and through holes (pos. A) fix
with main bar using bolts M8x30mm (pos. 11).
Through holes (pos. B) drill using bit ø11mm and next fix using bolt
6.
M10x40mm, bolt M10x60mm and using angle fish-plate (pos. 7).
7.
Underneath a car drill holes through points (pos. C) inside the trunk, use bit
A
ø9mm.
A
8.
Inside trunk put fish-plates (pos. 5) and through holes (pos. C) fix it by bolts
1
M8x30mm (pos. 11).
Through holes (pos. D) of fish-plates make holes ø9mm and fix by bolts
9.
M8x30mm (pos. 11) and washers.
10. Underneath a car through holes (pos. E) drill using bit ø9mm and fix by bolts
M8x30mm (pos. 11).
11. Cut out the bumper according to supplied template, then reassemble it to a
car.
12. Fix tow-ball (pos. 2) with socket plate (pos. 3) using bolts M12x75mm (pos.
2
8) from accessories.
13. Fix tight all bolts according to the torque shown in the table.
14. Connect electric wires of 7-poles socket according to the instruction of the
car. (Recommend to make at authorized service station).
15. Complete paint layer damaged during installation.
After install the towing hitch you should get adequate note in registration book (at
authorised service station).The car should be equipped with:
Indicators
Tow mirrors
After 1000km check all bolts and nuts. The ball of towing hitch must be always
kept clear and conserve with a grease.
The instruction of the assembly
Torque settings for nuts and bolts (8,8):
M 8 - 25 Nm
M 10 - 55 Nm
M 12 - 85 Nm
M 14 - 135 Nm
NOTE
Publicité
