AUTO-HAK V58 Instructions De Montage page 4

FITTING INSTRUCTION
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
C
4
9
9
9
A
Fig. 1
This towbar is designed to assembly in following cars:
NISSAN VANETTE, delivery VAN (C23 M/C) CARGO produced
since 01.1995 till 12.2001, catalogue no. V58 and is prepared to tow
trailers max total weight 1600 kg and max vertical load 80 kg.
From manufacturer
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and right
exploit. For this reasons we kindly ask to read carefully this instruction and apply
to hints.
The towbar should be install in points described by a car producer.
C
9
5
9
B
1
A
7
8
3
1. Put main bar of towbar (pos. 1) to rear part of the car in this way so
holes (pos. A) agree with original threaded holes and screw all using
bolts M10x1,25x35mm (pos. 9).
2. Element (pos. 4) put to towbar (left side) in this way, so holes (pos. B)
agree with holes in towbar and holes (pos. C) agree with original
threaded holes in chassis member and screw using bolts – see drawing.
9
3. Element (pos. 5) put to towbar (right side) and screw as described in
point 2.
4. Tighten all bolts according to the torque shown in the table.
A
5. Screw tow-ball (pos. 2) and socket plate (pos. 3) using bolts
8 M12x75mm (pos. 7) from accessories.
6. Connect electric wires of 7-poles socket according to the instruction of
the car. (Recommend to make at authorized service station)
Complete the paint coating damaged during installation.
7.
6
2
After install the towbar you should get adequate registration in registration book
(at authorised service station).The car should be equipped with:
Indicators
Tow mirrors
After 1000km check all bolts and nuts. The ball of towbar must be always kept
clear and conserve with a grease.
Fitting instruction
Torque settings for nuts and bolts (8,8):
M 8 25 Nm M 10 55 Nm
M 12 85 Nm M 14 135 Nm
NOTE