AUTO-HAK P07 Instructions De Montage page 4

FITTING INSTRUCTION
Clamp mark
in acc. with
Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
Chassis member
6 54 Stoplights
7 58L Left side parking lights
M10x90 mm
D
Use this hole for drill
L=60 mm L=53 mm
5 2
C
1 3
E
25x6 mm
4
This towing hitch is designed to assembly in following car:
CITROEN XM 5 doors (Y3/Y4), produced since 05.1989 till 03.2001, catalogue no.
P07 and is prepared to tow trailers max total weight 1800 kg and max vertical mass
80 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towing hitch depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and apply to
hints.
The towing hitch should be install in points described by a car producer.
The instruction of the assembly
1. In chassis members on the left and right side drill holes to trunk through original
hole (see drawing). Next inside trunk enlarge it using bit ø17,5mm. Put in
distance sleeves L=53mm (see drawing) and put on fish-plates from equipment
(pos. D).
M10x90 mm
D
L=60 mm
5
C
2
A 3
B
From manufacturer
2. Angle brackets (pos. C) fix through hole
pos. 1 and installed distance sleeves to
the chassis
M10x90mm. Fix loosely.
3. In axis of the bumper cut out it's
L=53 mm
fragment dimension: width 70 mm and
1
depth as necessary according to figure
beside.
E
4. To the chassis of car put main bar of the towbar (pos. A) and through
holes pos. 2 and 3 fix with already mounted side brackets (pos. C)
using bolts M10x45mm.
NOTE! Through hole pos. 3 fix element pos. E too.
5. In original hole of tow eye put distance sleeve ø25x6mm and fix
4
through hole (pos. 4) with element pos. C using bit M10x45mm from
25x6 mm
equipment.
6. Inside trunk bend side fish-plates pos. D and underneath a car through
hole pos. 5 of angle brackets drill holes inside trunk using bit ø11mm.
7. Inside trunk enlarge made holes by bit ø17,5mm. Put in distance
sleeves L=60mm, next position fish-plates pos. D and fix using bolts
M10x90mm
from towbar equipment.
8. Tighten all bolts according to the torque shown in the table.
9. Fix tow ball (pos. B) together with socket plate using bolts
M12x75mm from equipment.
10. Connect electric wires of 7-poles socket according to the
instruction of the car. (Recommend to make at authorized service
station).
11. Complete paint layer damaged during installation.
After install the towing hitch you should get adequate note in registration
book (at authorised service station). The car should be equipped with:
Indicators
Tow mirrors
After 1000km check all bolts and nuts. The ball of towing hitch must be
always kept clear and conserve with a grease.
ZDERZAK
BUMPER
members using bolts
Torque settings for nuts and bolts (8,8):
M 8 - 25 Nm M 10 - 55 Nm
M 12 - 85 Nm M 14 - 135 Nm
NOTE
WYCIĄĆ
CUT OUT