AUTO-HAK C09 Instructions De Montage page 4

FITTING INSTRUCTION
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
7
4
5
5
A
This towbar is designed to assembly in following cars:
FORD ESCORT 3/5 doors, Cabrio, Except 4x4, produced since 10.1992
till 12.1995, catalogue no. C09 and is prepared to tow trailers max total
weight 1200 kg and max vertical load 50 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towbar should be install in points described by a car producer.
7
5
A
1
6
3
From manufacturer
1. To install our towbar it is not necessary to disassemble a rear
bumper.
2. In factory marked points (inside trunk, left and right side)
knock out per two plugs ø24mm (use circular rod or
4
something similar). In maked holes slipdistance sleeves
5
L=50mm (pos. 5) and next put elments (pos. 4) from towbar
A
accessories.
3. Put main bar of towbar (pos. 1) from below the car and
through holes (pos. A), distance sleeves and fish-plates (pos.
4) screw using bolts M10x90mm (pos. 7).
4. Tighten all bolts according to the torque shown in the table.
5. Fix tow-ball (pos. 2) and socket plate (pos. 3) using bolts
M12x75mm (pos. 6) from accessories.
14
6. Connect electric wires of 7-poles socket according to the
instruction of the car. (Recommend to make at authorized
service station).
Complete the paint coating damaged during installation.
7.
2
After install the towbar you should get adequate note in registration book
(at authorised service station).The car should be equipped with:
Indicators
Tow mirrors
After 1000km check all bolts and nuts. The ball of towbar must be always
kept clear and conserve with a grease.
The instruction of the assembly
Torque settings for nuts and bolts (8,8):
M8 25 Nm M10 55 Nm
M12 85 Nm M14 135 Nm
NOTE