Panadero ONIX WALL Mode D'emploi page 7

5) The stove has a regulating
You need a metric key n°12 to handle this device shown on the illustration n°7.
Firstly, remove the external nut (Nut 1). After that calibrate the stove using the
internal nut (Nut 2):

In clockwise direction to lift the stove

In counter clockwise direction to lower the stove
Fasten the external nut (Nut 1) after calibration of the stove.
Ilustration 7. Location of the regulating service
1º
2º
Calibration of the stove
Ilustración 8.
Nut
Nut
44
7
Mod.
O N I X W A L L
2
1