Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
GENERAL
Installation of the kettle must be accomplished by qualified electrical installation personnel
working to all applicable local and national codes. Improper installation of product could cause
injury or damage.
INSTALLATION
The first installation step is to refer to the Specification Sheet for detailed clearance and bolting
requirements. Next, carefully cut open and remove the shipping carton. Remove all supports and
fasteners holding unit to the skid.
KETTLES
Table-top models must be positioned on a firm stand or existing counter top and secured in place.
An optional modular cabinet base (SD Stand), with level-adjustable legs is available .
A
1.
Make two 1" holes for the kettle legs.
2.
Remove the leg mounting locknuts and washers from the kettle's legs.
3.
Install the legs into the two 1" holes.
4.
Position washers as illustrated and secure the kettle to its' base by
refastening the locknut from underneath the cabinet or countertop.
5.
Once the kettle is secure, screw the tilt handle into the mounting block welded to the side
of the kettle.
6.
Install service requirements as required.
KETTLES WITH SD STAND
1.
Place unit in desired location.
2.
Place a carpenter's level on the kettle rim and level the stand using the level adjustable
feet.
3.
Install service requirements as required.
A
KDT-1-T
8 1/8" (203mm)
KDT-3-T
10" (254mm)
KDT-6-T
12" (304mm)
KDT-12-T
19 1/2" (356mm)
KDT-20-T
23 3/ (603mm)
Publicité
