Wiring & Subwoofer Installation; Crown Amplifier; Preparing The 4 Conductor Burial Cable - Martin Logan OUTDOOR LIVING Serie Mode D'emploi

WIRING & SUBWOOFER INSTALLATION
Mono Setup Using 4 Conductor Burial Cable & Crown Amplifier
Speakers and subs should be
wired in parallel, not series.

Preparing the 4 Conductor Burial Cable

1. S t a r t i n g w i t h
the first speaker
a n d e v e r y
s p e a k e r / s u b
that comes after,
create a loop
approximately
6" in length .
3. Use a Round
Cable Stripper
t o r e m o v e
t h e o u t s i d e
protective cable
Wires for
jacket to expose
Subwoofer
the four color-
green (+) &
coded wires .
white (-)
Separate the
wire loops as
shown .
Mono Mono Mono Mono
SAT 40 OR SAT 60 (70V or 8-Ohm)
2. Recommended:
4. Cut the white (+)
Wires for
Speaker
red (+) &
black (-)
SUB 100 OR SUB120 (8 Ohm)
Mono Mono Mono
Use a wire tie
(not included) to
keep the wire
loop intact and
act as a strain
relief .
and green (-)
wires with cable
strippers and
strip off 1 inch
(25 .4mm) of
insulation from
the ends of the
wires to expose
t h e c o p p e r
conductor .
Mono
8