Subwoofer Assembly; Subwoofer Positioning - Martin Logan OUTDOOR LIVING Serie Mode D'emploi

SUBWOOFER ASSEMBLY

Dynamo Outdoor SUB 100
™
To assemble, place the canopy into the port tube and
tighten the compression clamp so to ensure a water
tight seal .
Dynamo Outdoor SUB 120 (See diagram)
™
Note: The port elbow is clearly marked "To Canopy" and "To
Subwoofer" .
Step 1: Insert the canopy onto the one end of the port elbow
until it is seated properly . Fully tighten the compression clamp .
Step 2: Attach the assembled canopy and elbow port to the
subwoofer, ensuring that dirt and other debris do not enter the
port tube . Do not fully tighten the compression clamp that holds
the elbow port to the subwoofer .

SUBWOOFER POSITIONING

Dynamo Outdoor SUB 100
™
Place the subwoofer into the hole, ensure there is approximately
5" between the ground level and the bottom of the canopy .
Dynamo Outdoor SUB 120 (See diagram)
™
Place the assembled subwoofer into the hole, then rotate the
subwoofer cabinet until there is approximately 5" between
the ground level and the bottom of the canopy . Once the
positioning of the subwoofer is satisfactory, tighten the
compression clamp that holds the elbow port to the subwoofer .
IMPORTANT! Do not backfill hole until your system
is fully WIRED/tested.
Shown: Dynamo
™
Outdoor SUB 120
Step 1 Step 2
Shown: Dynamo
™
Outdoor SUB 120
Ground
Level
16"
Example 2
Example 1
5"
16"
16"
32"
Example 3
6