Ebode IR Link Mini PM18 Guide Utilisateur page 3

3. INSTALLATION OF THE IR TRANSMITTER
See figure 1.
1. Insert the supplied power adapter into the power socket
(230V-50Hz) and insert the power plug into the DC
input [A] at the backside of the IR transmitter. Use strictly
the supplied adapter!
2. Place the IR transmitter at a maximum distance of 6 meters
form the A/V equipment (DVD player, decoder, video, stereo,
etc.) that you want to operate. Point the front side (with the Figure 1
logo) of the IR transmitter at the A/V equipment.
Beware: It is important for the proper function of the system that the antenna wire [B] stays free
and does not get covered by the metal casing of e.g. A/V equipment.
4. INSTALLATION OF THE IR RECEIVER See figure 2.
1. Open the IR receiver by sliding down the cover at the
backside.
2. Place the 2 additionally supplied AAA 1.5V batteries into the
IR receiver.
Be careful about the polarity (+/-). This is indicated at the
inside of the IR receiver. Use strictly non-rechargeable
(Alkaline) batteries. Slide the cover back onto the IR receiver.
3. Place the IR receiver within the range of your remote control
(maximum 6 meters). Make sure that the front side (with the
logo) is facing you.
The IR receiver can be moved freely due to the wireless
technology. However, it is important to place it within the sight
and range of your remote control. Experiment with its position for the Figure 2
best result.
5. USAGE
1. Make sure that the A/V equipment is switched on.
2. Point your remote control at the PM18 IR LINK MINI IR receiver. The IR receiver receives the
infrared signal, transforms it into an RF signal and transmits it to the PM18 IR LINK MINI IR
Transmitter. The IR Transmitter then transforms this signal again into an infrared signal, which is
transmitted to your DVD-player, decoder, video, stereo-equipment, etc. When you want to
operate your equipment from several rooms, you can make use of several additional IR
receivers (Art. no. RE18).
6. INSTALLATION OF THE IR EXTENDER CABLE (EXLED3)
When you can't place the IR transmitter within the sight of your A/V equipment (because it is
in a closed cupboard, for example), then you can place the IR transmitter next to or on your
A/V equipment with the use of an additional IR Diode (EXLED3).
1. Connect the IR extender cable to the output [C] at the backside of the IR transmitter (see
figure 1).
2. Remove the protection foil from one of the IR LEDs. Place this IR LED on the IR window of the
A/V equipment that you want to operate. Don't press it down too much yet. It is
recommended that you check the function of the IR LED before its definite attachment. Point
16-8-2010 3 033000H14719A