Leister MISTRAL PREMIUM Notice D'utilisation page 29

Function heating element and tool protection
If the heating element or device overheats (air intake temperature is too warm or warm air back pressure), the
power to the heating element is interrupted. For the MISTRAL SYSTEM, the work contact of the alarm relay opens
simultaneously. If the heating element protection or device protection signals, the following steps should be followed
to reset the device for safety reasons.
PREMIUM
A Switch off heating capacity
(set potentiometer (10) to 0)
B Let the device cool
D Check air intake / and output opening and clean if necessary.
Nozzle definition air output opening
MISTRAL SYSTEM (heating element pipe ∅ 36.5 mm)
Nozzle setting
Load 0
Load 1
Load 2
Nozzle definition air output opening
MISTRAL SYSTEM (heating element pipe ∅ 50 mm)
Nozzle setting
Load 0
Load 1
Load 2
SYSTEM
A Let the device cool
B Disconnect the power cord from the mains
C After 10 seconds, plug the device into the mains again.
Nozzle type
-
Wide slot nozzle
Wide slot nozzle
Nozzle type
-
Wide slot nozzle
Wide slot nozzle
Item no. Air output opening (mm²)
-
108.078
107.261
Item no. Air output opening (mm²)
-
105.961
106.057
380
400
280
706
540
400
29