Shop-Vac EAL Serie Manuel D'utilisation page 8

FILTER INSTALLATION AND CLEANING (CONT'D.)
2. Remove filter cleaner brush. Remove filter retainer and cartridge filter.
3. Align the brush tabs with the opening of the locking unit on the rods. Snap the brush
tabs into the locking unit on the rods. Brush is now locked in place.
4. Place the new cartridge filter and retainer into place.
Filter cleaner brush must be removed for wet pickup or when using a foam sleeve.
WARNING
DEPENDENT ON THE FILTER. A CLOGGED FILTER CAN CAUSE OVERHEATING AND POSSIBLY
DAMAGE THE CLEANER. CHECK THE FILTER PERIODICALLY AND REPLACE AS REQUIRED.
INSTALLING THE DISPOSABLE FILTER BAG:
WARNING
BEFORE REMOVING THE TANK COVER.
1. Use the disposable filter bag in conjunction with the cartridge filter for easy disposal of the debris. The
bag is not required for normal dry pick up. When picking up fine dust or powders a high efficiency filter
bag (not standard with all models) must be used.
NOTE: Use for dry pick up only.
2. With cord disconnected from the receptacle, pull latches in an outward motion from the bottom and
remove the tank cover.
3. Unscrew hose locking-nut and remove hose from inlet.
4. Remove the inlet deflector from the deflector guide. NOTE: Hose must be removed
before the inlet deflector can be taken out.
5. Position the inlet deflector with the opening facing the left or the right side of the filter
bag. Slide the filter bag collar over the inlet deflector, matching the notches of the bag
collar to the tabs on the inlet deflector. Bag will only fit properly one way.
PAGE 8
–
KEEP FILTERS CLEAN. EFFICIENCY OF THE VACUUM IS LARGELY
–
ALWAYS DISCONNECT THE PLUG FROM THE WALL OUTLET