Connecting Electrical Loads; Stopping The Engine - Briggs & Stratton 030467 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Connecting Electrical Loads

1. Let engine stabilize and warm up for a few minutes
after starting.
2. Ensure circuit breaker on control panel is in "On"
position.
3. Plug in and turn on the desired 120 and /or 240 Volt
AC, single phase, 60 Hz electrical loads.
NOTICE When plugging into the 120 Volt receptacles, plug
items to be powered in sequence as shown below.
1
2
NOTICE
• DO NOT connect 240 Volt loads to the 120 Volt duplex
receptacles.
• DO NOT connect 3-phase loads to the generator.
• DO NOT connect 50 Hz loads to the generator.
• DO NOT OVERLOAD THE GENERATOR. See Don't
Overload Generator.
NOTICE Exceeding generators wattage/amperage capacity
could damage generator and/or electrical devices connected
to it.
• DO NOT exceed the generator's wattage/amperage capacity. See
Don't Overload Generator in the Operation section.
• Start generator and let engine stabilize before connecting
electrical loads.
• Connect electrical loads in OFF position, then turn ON for
operation.
• Turn electrical loads OFF and disconnect from generator before
stopping generator.

Stopping the Engine

1. Turn OFF and unplug all electrical loads from generator
2. Let engine run at no-load for several minutes to
3. Push engine rocker switch to OFF or O position.
• DO NOT stop engine by moving choke control to "Choke"
position
3
4. Move fuel valve to "Off" position.
4
panel receptacles. NEVER start or stop engine with
electrical devices plugged in and turned ON.
stabilize internal temperatures of engine and generator.
WARNING Fuel and its vapors are extremely flammable
and explosive which could cause burns,
fire or explosion resulting in death or
serious injury.
(
)
.
13

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

030468030469

Table des Matières