HJC C70 Mode D'emploi page 6

Crown Pad Removal
1. Grasp the crown pad fabric as close as possible to its plastic base and pull/pry away from the helmet. Notice how
the crown pad plastic section aligns with the shell plastic sleeve. This will help orient you with the reinstallation.
2. Repeat same at rear.
Crown Pad Installation
1. Install the front section first by aligning the plastic shell base and the crown pad plastic sleeve, ensuring that the center
and side holes are properly aligned. Press the crown pad plastic sleeve (center portion) into the center of the channel
which is built into the plasticshell base, working your way outward to each side.
2. Align and snap the two rear snaps into place.
Try not to operate the sunlight film while riding as this may impair your vision and may lead to an accident.
DO NOT pull on the sunlight film when it is already down. The sunlight film may be ejected and this will increase
the risk of serious injury or death in the event of an accident.
Do not attempt to adjust the sunlight film itself with your hands. Always use the sunlight film lever.
DO NOT use sunlight film at night time. The sunlight film is only for day time use. The sunlight film does not provide
eye protection. When you use the sunlight film be sure that the clear visor is also in closed position
Sunlight film Operation
Above illustration shows raised
sunlight film position.
Lever
Sunlight film Removal
9
Above illustration shows lowered
sunlight film position.
Lever
1. Grasp and pull the center of the sunlight film
by reaching inside the helmet through
the bottom opening.
2. With the center portion of the sunlight film
released from its mount, pull the sunlight film
completely free from the helmet through
the eye port.
Sunlight film Installation
1. Push each side into place, aligned with the pivot tabs.
2. While holding the sunlight film lever in 'lowered position' insert the center hook into the center buckle using the other hand.
Pivot Tab
Breath Deflector Installation
1. Align and press the breath deflector snaps into place.
Breath Deflector Removal
1. Grasp the breath deflector at the side tab area and gently pull.
Chin Curtain Installation
1. Center the front plastic sleeve of the chin curtain with the shell. Force the chin curtain's plastic sleeve fully
in between the shell and EPS.
Chin Curtain Removal
1. Grasp the chin curtain fabric in the middle and gently pull the sleeve up and away from the shell.
Center Buckle Center Buckle(B)
Sunlight film
Make sure tabs & center buckle are secure in order
for sunlight film to function properly.
10