Publicité
Les langues disponibles
Les langues disponibles
To connect the inner tube (10) to the motor unit, you must first screw the fixing
screw (19) to the inner tube (10). The inner tube is located in the outer tube when
delivered and can be pulled out with your fingers. You can then fasten the remain-
ing screws (16, 17, 18).
Note: If the screws are not in the packaging bag, they are usually pre-assembled at
the point where they are to be inserted.
6. Usage
Keep the fan in an appropriate location and connect the device to a properly
installed 220-240V AC socket.
By loosening the tilt setting (16) and then tipping the protective cage, you can
change the angle of inclination according to your needs. Then tighten the tilt
setting at the desired position.
Push the pin at the top to enable the oscillation. If you do not want to use the
oscillation function, pull the pin out slightly.
You can select between three different speed levels using the rotary switch on the
motor unit.
Speed level
0
1
2
3
7. Cleaning
Pull out the power plug from the socket before starting with the cleaning process!
Use a slightly moist cloth for cleaning (wetted with water). For cleaning, never
immerse the device into water! This could lead to electric shock or fire!
8. Safety instructions and liability disclaimer
Never try to open the device to carry out repairs or conversions. Avoid contact with
mains voltages. Do not short-circuit the product. The device is not certified for use
in the open air; only use it in dry conditions. Protect it from high humidity, water
54
Off
Slow
Medium
Fast
English
Publicité
