Hornbach 6145087 Manuel D'installation Et De L'utilisateur page 120

Installation
Install pole foot (e.g. in
concrete).
Make sure the ground / instal-
lation site is plain and level, so
that the awning can sit solidly.
For concrete, use a 14 mm ma-
sonry drill to drill the holes for
the pole foot. The holes should
be 46 x 65 mm apart (centre to
centre) and min. 80 mm deep.
To install the pole foot, insert
the rawl-bolts through its base
in the drill holes and tighten
them securely.
Install the brackets to the pole
foot using the four pole screws,
washers and nuts.
In the event that you install the
brackets to a wall instead of the
foot, make sure the wall is plain,
so that the brackets sit solidly.
Drill holes and install mounting
brackets. (e.g. in brick wall)
After choosing the mounting
position you can mark where
you need to drill holes for the
brackets and install the fasten-
ings according to the instruc-
tions of the manufacturer.
120 | ENGLISH
1a
65 mm
1b
48 mm
46 mm