Table Des Matières - Global Industrial WB988295 Directives D'assemblage

5. While holding both latches up, lift the top
frame past the latches until it is at its full,
uppermost position. Have the assistant hold
the weight and insert the pivot pin in the hole
in the base frame. See Fig. 8. With the unit
in this full upper most position the orange
spring can be installed.
Fig. 7
Fig. 8
6. Insert either end of the large orange
spring into the lower pocket. Be sure
the bottom spring coil is positioned
outside the alignment tab as shown.
Fig. 9
13. Figure 18 shows the position of additional springs if needed. Double-check to be sure
you have the correct springs. Refer to Table 1 and see that you have the correct springs
for your application.
Range #1
Fig. 18 Spring Mounting Positions
Spring-Actuated Pallet Carousel Skid Positioner
7. Grasp the spring by the second or third coil
down from the top (DO NOT grasp the top
coil or rung) and push the spring down and
under the edge of the top frame.
Fig. 10
8. While pushing down to compress the spring,
push it forward into the pocket up under the
top frame. It will "snap" into position when
completely in the pocket.
Fig. 11
Fig. 13
INCORRECT
Spring not
fully inserted into
pocket
Range #2
9. Remove the shock absorber pivot pin. Push
Fig. 14
10. Reinstall the shock absorber pivot pin and
Fig. 15
11. Install additional springs as needed through
Fig. 12
CORRECT
Fully inserted into
pocket
Fig. 16
12. Reinstall the rotator ring.
Fig. 17
Range #3
4
down on top frame until latches engage.
(Both latches will drop into place).
linch pin.
the bayonet openings. Reinsert the yellow
bayonets and twist to lock them in place.
Range #4