Remote Control
Your remote control handset is powered by two (2) AAA type batteries
•
battery
•
Effective remote range is approximately 16 feet at an angle
of no greater than 30° to the left / right or 20° up /down to
the IR sensor.
•
To avoid possible damage from battery chemical leakage,
remove the batteries if you do not plan to use the remote for
an extended period of time. Do not mix batteries of different
age and / or type. Always discard used batteries safely.
•
Do not expose the remote control to liquids, direct sun-light
or sources of excessive heat.
•
The IR receiver on the TV will not work properly if the set is
in direct sunlight.
NOTE: Improper use of batteries can result in a chemical
leakage or explosion.
Cable / Satellite Remote Control Codes:
NOTE:
The remote control from your Cable/Satellite provider can be programmed to operate
most of the major functions of this TV which include:
VOLUME - , CHANNEL +, CHANNEL - , SELECT/OK/ENTER
buttons. For non-major TV functions not listed, use the remote control included with this TV.
o program your Cable / Satellite remote to operate this TV, follow the programming instructions
T
included with your providers' remote and use the following codes.
Comcast or Direct TV : 10030
AT & T (U-verse) : 1043
Dish Network : 506
RCA Universal : 0030
cover.
•
•
Battery Install
30
30
POWER, INPUT / SOURCE, VOLUME +,
(based on your remote), and
7
IR Receiver
NUMBER