Kreg KMA4100 Guide D'utilisateur page 5

3
Attach the Guide Rails
WARNING Ensure rails are installed per the instructions below to keep your hand a safe distance from the
rotating blade while cutting.
a. Ensure your saw blade is as centered as possible on the cutting surface. To accomplish this, set your fixed
saw guide rail (B) on the front and back boards (H and E) on the side opposite of your blade (as shown).
b. Set your adjustable saw guide rail (C) on the front and back boards (H and E) to the width of your saw base
plate.
c. Position the saw so that the blade is as centered as possible, and secure the fixed saw guide rail (B) to the
corresponding holes in the front and back boards (H and E).
Note Depending on your saw type, this may result in the fixed rail being opposite the picture shown. The
goal is to have your saw blade positioned as centered as much as possible in the cutting surface.
B
4
Attach the Rail Brackets
a. Set your saw aside and connect the adjustable saw
guide rail brackets (BB) to the closest available
holes on the front and back boards (H and E) using
small screws (AA).
b. Tighten the top screws on the brackets (BB) to fix
rail in place.
H
AA
5
Attach the Fence and Clamps
a. If needed, slide the adjustable fence (G) and/or
material hold-down clamps (F) into place on the
material support wings (D).
BB
AA
C
E
F
G
D
5