GEZE TS 5000 E-ISM BG Mode D'emploi page 16

Mounting and securing
Pull out driver as far as possible (1.).
X
Loosen screws of stop rod (max. ½ rotation) (2.).
X
Stop rod may not pass under driver..
Pull out stop rod (3.).
X
à Distance between edge block and stop is approx. 30 mm
Close moving leaf (4.).
X
Stop rod for function safeguard of the integrated closing sequence control is in position.
Open moving leaf (5.).
X
Tighten screws of stop rod (6.).
X
6. 1 0 Adjusting electrical hold-open device
Moving leaf is shown.
Open door leaf to desired hold-open angle and fix it there (1.).
X
Remove cable protection foils from guide (2.).
X
Loosen clamping screws of electrical hold-open device (3.).
X
Move electrical hold-open device until catch contacts sliding block (4.).
X
Screw down electrical hold-open device securely (5.).
X
To prevent loops from forming, tighten cable and fasten cable protection at hold open device end (6.).
X
Stow away (7.) loose cable in the cable protection and free area.
X
Secure exposed cable with the cable protection film (8.).
X
CAUTION!
Check free upward movement of the rocker!
X
9.
If necessary, the holding force can be adjusted (9.). According to EN 1155, the release torque should
amount to 40 Nm - 120 Nm for a door with 90° hold- open angle.
6. 1 1 Mounting cover panel
CAUTION!
Do not pinch cable.
X
GB 8
TS 5000 E-ISM BG
Fig.: 6.10.1