Publicité
How to maintain
ENGLISH
Changing the filter collection bags
1. Turn off the main power switch and unplug unit from wall
outlet (Fig. 1).
2. Remove vacuum hose from top of unit (Fig 2).
3. Release the two latches and lift off lid (Fig. 3).
4. Separate lid from paper bag insert and dispose of paper
bag (Fig. 4).
5. Remove cloth filter bag, clean, dust and replace (Fig. 5).
6. Insert new paper bag making sure to align lid nozzle with
bag hole and replace latches (Fig. 6).
Changing the exhaust filter assembly
The vacuum cleaner is equipped with a pleated pre-motor
filter and an exhaust filter. These filters capture fine dust
particles and protect the motor from dirt. It is important to
replace the pre-motor filter and exhaust filter approximately
every six months.
To change or clean the exhaust filter
1. Turn off the main power switch and unplug unit from wall
outlet (Fig. 1).
2. Detach the exhaust filter holder from the bottom of the
unit (Fig. 7).
3. Remove the exhaust filter from the holder (Fig. 8).
4. Do not throw away the filter holder.
5. Remove the exhaust filter from the plastic holder and
shake or brush dirt from the filter.
6. Replace the exhaust filter in the plastic holder and place
into vacuum.
Changing the pre-motor filter
1. Unplug the unit. Remove the lid, paper bag and cloth
bag to expose the filter.
2. Remove the filter cap on the top of the filter (Fig. 9).
3. Remove the filter from the dust compartment
4. Insert a new filter and replace the filter cap (Fig. 10).
Refit the cloth bag, paper bag, and replace lid.
NOTE: The filter can NOT be washed and reused.
• Clean the cloth vacuum bag regularly. After emptying the
vacuum bag, turn it inside out and shake as much dust out
of the fabric as possible. Optimum performance is achieved
by using a paper filter bag with the cloth bag.
• Clean the vacuum bag and filter or free any blockage and
ensure that adequate airflow is restored.
• Use only approved paper filter bags.
• Check the power cord for damage and replace if damaged.
• Always unwind the cord completely.
• Ensure the vacuum hose, the extension wand and the
vacuuming accessories are not blocked.
• Ensure that the electrical outlet and the plug are securely
connected. Incorrect connections may cause sparking and
damage to the cable socket.
• Have your unit serviced by an authorized repair service
center if you suspect any potential problems.
• Ensure that the flexible vacuum bag ring provides a proper
seal before vacuuming.
8
1
3
5
7
9
2
4
6
8
10
Publicité
