Publicité
Les langues disponibles
Les langues disponibles
2 . Be aware that this tool is always in operating condition,
because it does not have to be plugged into an electrical outlet .
3 . Always be sure you have firm footing .
4 . Be sure no one is below when using the tool in high locations .
5 . Hold the tool firmly and use both hands .
6 . Keep hands and hair away from rotating parts .
7 . Do not leave the tool running . Do not force tool to stay in the
"on" position . Operate the tool only when hand-held .
8 . Do not touch the drill bit, impact socket, any adapter, or the
workpiece immediately after operation; they may be extremely
hot and could burn your skin .
OPERATING INSTRUCTION
Installing Or Removing Battery Pack
1 . Your new battery pack is not fully charged . You may need to
charge before use .
2 . Make sure the forward/reverse lever is in the neutral position
when installing or removing a battery .
3 . To remove a battery, depress the front tab and pull the
battery forward and the tool in the opposite direction .
4 . To install a 10 .8V battery align the tool with the battery,
place the front of the tool about halfway up the battery, push
forward until click is heard indicating full installment .
4 .
Charging The Battery Pack
MUC108LC
MUC108LC 10.8V Li-ion Charger
Power On
(Green light flashes slowly)
Battery Low
(Red light stays illuminated)
Battery charged 80%
(Green light flashes rapidly)
Battery charged 100%
(Green light stays illuminated)
Battery Pack temperature is too hot
or too cold (Red light flashes slowly)
Battery Pack malfunction
(Red and Green lights stay
illuminated)
9 . Some material contains chemicals which may be toxic . Take
caution to prevent working dust inhalation and skin contact .
Follow material supplier safety data .
WARNING:
MISUSE or failure to follow the safety rules stated in
this instruction manual may cause serious personal
injury.
Charging The Battery Pack
1 . Battery may not charge when it is above a certain preset
temperature limit . Allow temperature of battery to cool before
charging .
2 . The charge process will take less than one hour .
3 . After charging, unplug the charger from the power source
and stow away in a safe place .
Tool Operation
• Plug charge station into a 100-240VAC outlet.
• If the battery pack is excessively hot or cold, the charger
will not begin charging and the red indicator on the charging
station will blink . When the battery returns to between 0°C
(32°F) and 50°C (122°F), the charger will automatically
begin charging . Ensure the charging ambient temperature is
between 0°C (32°F) and 40°C (104°F) .
• If both the red and green indicator lights are ON, the battery
pack does not comply or is defective . Please contact your
retailer .
• The charging process will take less than 60 minutes.
• Unplug the unit after the charging process and keep in a dry,
cool place .
Also available separately RSLIBCPC, Li-ion Charger Power Cord .
3
rev. 09/09/09
Publicité
