Publicité
Les langues disponibles
Les langues disponibles
E N G L I S H
E N G L I S H
Laundry Care Symbols
REASSEMBLING THE JAY J3 CUSHION
AFTER CLEANING
Follow cleaning and maintenance instructions as described in "Easy
maintenance and cleaning" then reassemble as follows.
Insert the Jay Fluid pad on the foam base making sure that all
Velcro® strip locations are aligned. A misalignment or creation
of an edge could cause an unwanted pressure point which could
Insert the foam base into the outer cover. Ensure that the zipper is
at the rear of the foam base (the part number tag should be to the
rear of the foam base) where the pelvic loading area is located.
Supplemental
fluid pads
(Field Variable
version only)
PLA reducer
(if applicable)
109578 Rev. A
Machine wash in warm water
(60° C)
Only non-chlorine bleach,
when needed
Drip dry
Do not iron
Do not dry clean
WARNING
lead to injury.
Fluid insert
Foam base
4
JAY J 3 C U S H I O N
Publicité
