Electrical Connection; Drainage Connection; Recycling - ASBER GCPNZ-1402/2 Instructions D'installation, D'utilisation Et D'entretien

EN

4.3 Electrical connection

Electrical connection must be carried out by an AUTHORISED TECHNICIAN
The legal standards in force in each country regarding connection to the mains should be taken into
account.
The manufacturer will not be held liable for any personal or material damage to the
machine resulting from incorrect installation or failure to comply with the manufacturer's
specifications.
The electric specifications of the machine are shown in the specification plate. Section 3.
There are 220V 60Hz and 115v 60 Hz versions, with the currents on the nameplate

4.4 Drainage connection

In fish storage cabinet, drainage hose of the cabinet should be connected to the water drainage
network. Check figures 1 - 16 to see the position of the drainage.

4.5 Recycling

The product packaging consists of:

A wooden pallet.

Cardboard.

A polypropylene band.

Expanded polyethylene.
All the packaging used around the machine can be recycled; The correct disposal of these products
will help to protect the environment. For further information regarding the recycling of these products,
please refer to the relevant office of the local body. Dispose of these materials in accordance with
current legislation.

Check that the mains voltage corresponds to that indicated on the nameplate.

It is essential that the electrical installation where the cabinet is going to be
connected has an EARTHING SOCKET, in addition to the appropriate
magneto-thermal switch and differential protection (we recommend 30 mA)

The appliance must be earthed using a differential protector. The manufacturer
will not be held liable for damage originated by failure to observe this
requirement.

The cross-section of the power cable must be suitable for the rated current of
the machine.

The plug should be Schuko type with grounding and terminals of 4.8mm (F type)
. It is forbidden to enlarge the plug for your safety. As optional, the equipment
can be supplied with British type plugs (H type) or American type plugs (B type).

If any faults are observed during the installation, the supplier should be notified
immediately.
-27-