Description; Identi Cation - Greenlee G10 Tugger Manuel D'instructions

Description

The Greenlee G10 Tugger™ Portable Cable Puller is
intended to be used to pull cable through conduit and in
tray. The G10 Tugger™ will develop 44.5 kN (10,000 lb)
of pulling force. Refer to a Greenlee catalog for sheaves,
pulling rope, and other cable pulling accessories to
create an entire cable pulling system.
No single manual can provide instructions for every
possible cable pulling application; this manual contains
general information necessary to accomplish cable
pulls setup with the boom mount, oor mount and
chain mount. This tool should only be operated by
appropriately trained professionals.
Safety
Safety is essential in the use and maintenance of
Greenlee tools and equipment. This instruction manual
and any markings on the tool provide information
for avoiding hazards and unsafe practices related
to the use of this tool. Observe all of the safety
information provided.
Identification
G10 Cable Puller
1. Motor
2. Force Gauge
3. Foot Switch Jack
4. Adjustable Sheave Bar
5. Hitch Clip
6. Rope Tie-Off
7. Rope Ramp
8. Mounting Plates
9. On/Off Switch
10. Circuit Breaker
11. Removable Power
12. Control Box
13. Gearbox
14. Tapered Steel Capstan
15. Right Angle Sheave
Greenlee Tools, Inc.
2
8
7
6
5
G10 Tugger™ Portable Cable Puller
Purpose of this Manual
This manual is intended to familiarize all personnel with
the safe operation and maintenance procedures for the
Greenlee G10 Tugger™ Portable Cable Puller.
Keep this manual available to all personnel.
Replacement manuals are available upon request at no
charge at www.greenlee.com.
All speci cations are nominal and may change as design
improvements occur. Greenlee Tools, Inc. shall not be liable for
damages resulting from misapplication or misuse of its products.
1
3
4
9
10
11
9
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
15
13
12
14