Chain Mount Setup - Greenlee G10 Tugger Manuel D'instructions

Setup—Chain Mount
Requires: Exposed metallic conduit with the following
characteristics:
• 63.5 mm to 254 mm (2-1/2" to 10") in diameter
• Capable of withstanding at least 44.5 kN (10,000 lb)
of force
Do not mount the chain mount to
the following:
• Steel conduit less than 63.5 mm
(2-1/2") in diameter
• PVC conduit of any size
These conduits will not support the loads
imposed by the puller.
Failure to observe this warning could
result in severe injury or death.
When setting up the pipe adapter, do
NO
not use the vise chains on a structural
support that is less than 51 mm (2")
or more than 254 mm (10") wide. An
oversized or undersized structural
support can allow the puller to slide or
NO
break loose and strike nearby personnel.
Failure to observe this warning could
result in severe injury or death.

CHAIN MOUNT SETUP

Install vise chains properly.
• Follow the vise chain tightening
instructions carefully. Improperly
tightened chains can allow the puller
to slide or break loose and strike
nearby personnel.
• Do not mount the chain mount to
steel conduit less than 63.5 mm
(2-1/2") in diameter. This will not
support the loads imposed by
the puller.
• Do not mount the chain mount to
PVC conduit of any size. This will
not support the loads imposed by
the puller.
• Do not setup the vise chains on a
structural support that is less than
51 mm (2") or more than 254 mm
(10") wide. Mounting to an undersized
or oversized structural support can
allow the puller to slide or break loose
and strike nearby personnel.
• Do not allow the vise chains to bind at
the corners when mounting the puller
to a square or rectangular support. The
vise chains must be uniformly tight at
all points.
Greenlee Tools, Inc.
G10 Tugger™ Portable Cable Puller
Do not pull between the 10 o'clock and 2 o'clock
directions. Pulling between 10 o'clock and 2 o'clock
could damage the mounting conduit.
11
Pulling
10
Rope
Pull
Pull
Load
Load
9
22
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
12
O'CLOCK
1
Tailing
Rope
Support
Vise Chains
6
O'CLOCK
O'CLOCK
2
3