Set-Up, Adjustment & Use; Notes; Tools You Will Need; Check Out - Sunrise Medical Quickie Melody Mode D'emploi

E N G L I S H
VIII. SET-UP, ADJUSTMENT & USE

NOTES:

1. Work Surface For Set-Up:
Use a flat surface, such as a table, to assemble, adjust and check your chair. This makes the steps easier
and helps ensure a correct set-up.
2. Fasteners:
• Many of the screws and bolts on this chair are special high-strength fasteners and may have special
coatings.
• Many nuts are of the Nylock type. They have a plastic insert to help prevent loosening.
1. Use of improper fasteners may cause the chair to fail.
2. Over- or under-tightened fasteners may fail or cause damage to chair parts.
3. If bolts or screws become loose, tighten them as soon as you can. Loose bolts or screws
can cause damage to other chair parts causing them to fail.
3. Washers & Spacers:
• Note the position of washers and spacers before disassembly.
• To avoid damage to the frame, replace all washers and spacers when you reassemble parts.
4. Torque Settings:
• A torque setting is the optimal tightening for a particular fastener. Use a torque wrench that
measures 120 inch-pounds to secure screws, nuts and bolts on this chair.
NOTE– Unless otherwise noted, use a torque setting of 120 inch-pounds for all fasteners.

TOOLS YOU WILL NEED

1. Basic Tool Kit:
To set-up, adjust and maintain your chair you will need the following tools:
• 5mm Allen Wrench
• 6mm Allen Wrench
• 8 mm Open-end Wrench
• 10 mm Open-end Wrench
• 13mm Open-end Wrench
• 17mm Open-end Wrench
• Phillips screwdriver #2
• 13mm Socket Wrench
You can obtain a multi-purpose tool kit from Sunrise, or buy the tools you need from a hardware store.
2. Torque Wrench:
If you plan to adjust and maintain this chair yourself, Sunrise recommends that you use a torque wrench.
NOTE– The wrench must measure inch-pounds. You can buy a torque wrench and proper sockets from a
hardware store.
CHECK-OUT
Be sure this chair performs to your chosen operational settings. If it does not, turn the chair off immedi-
ately and have your supplier reprogram your wheelchair as needed
NOTE– Repeat this procedure until the chair performs to your specifications.
When properly set up, this chair will operate smoothly. Check to see that
all components work properly. If you detect a problem, be sure to correct
it before use.
V I I I . S E T- U P, A D J U S T M E N T & U S E
11
101266 Rev. B