Inserting Color Filter Frame//Exchanging Color Filter; Rigging - EuroLite TMP-150 Mode D'emploi

Procedure:
Step 1: Open the lampholder cover by loosening the fixation screw.
Step 2: If replacing the lamp, remove the old lamp from the spot.
Step 3: Insert the lamp in the lampholder.
Step 4: Insert the lampholder and close the device.

Inserting color filter frame//Exchanging color filter

Before exchanging color filter let the device cool down.
If you wish to insert the color filter frame or if the color filter is to be
exchanged, please follow the instructions below:
Step 1: Open the color filter frame cover by unscrewing the
four fastening screws by means of a suitable
screwdriver (see drawing).
Step 2: Now you can remove/insert the color filter frame and
exchange the color filter.
Step 3: Reposition the color filter frame and close the device.
Do not operate this device with opened cover!

Rigging

The installation of the projector has to be built and constructed in a way that it can hold 10 times the weight
for 1 hour without any harming deformation.
The installation must always be secured with a secondary safety attachment, e.g. an appropriate catch net.
This secondary safety attachment must be constructed in a way that no part of the installation can fall down
if the main attachment fails.
When rigging, derigging or servicing the fixture staying in the area below the installation place, on bridges,
under high working places and other endangered areas is forbidden.
Do not operate this device with opened housing!
Install the color filter with the device switched off only.
Unplug from mains before!
DANGER!
23/57 00021435.DOC, Version 1.1